Commercial AC Preventative Maintenance in South Austin, TX

Service Date: April 9, 2026 | Austin, TX

Setpoint Services dispatched technician Han Li to a commercial facility in south Austin for a scheduled preventative maintenance visit covering four HVAC systems — two rooftop units and two split systems. The goal was straightforward: inspect every unit, clean critical components, verify proper operation, and flag anything that could become a costly failure before it gets the chance.

Systems Serviced

Han Li performed full preventative maintenance on the following units:

• Daikin RTU (Front Office) — Model DRC1204D000001SAA | R410A refrigerant
• Carrier RTU with Gas Heat — Model 48FCDM16A2A6A0A0A0 | R410A refrigerant
• Carrier Split System (Unit 2) — Model 24SPA661W301 | R410A refrigerant
• Split System (Unit 1) — R22 refrigerant; model/serial not legible

Scope of Work Performed

All four systems received a comprehensive PM inspection. Work completed included:

• Checked refrigerant pressures on all units and confirmed readings within normal operating range
• Cleaned condenser coils on all systems to maintain heat transfer efficiency
• Cleared and flushed condensate drain lines for all RTUs and split systems
• Verified all secondary drain pans were dry and draining properly
• Replaced air filters — including (2) 20×25×2 and (2) 25×25×2 on the Daikin RTU, and (6) 18×24×2 on the Carrier RTU
• Performed full operational inspections on all units to verify proper system performance

System Condition & Recommendations

All four systems were operating within normal conditions at the time of service. One issue was identified that warrants follow-up attention:

Split System — Unit 1 (R22): The contactor was found to be worn with pitted contacts and was producing a buzzing noise when energized. Han Li recommends replacing this contactor to prevent an unexpected failure and ensure reliable operation heading into peak cooling season.

Identifying a failing contactor during a scheduled PM visit is exactly what preventative maintenance is designed to do — catching the small problems before they become emergency calls and extended downtime. Setpoint Services can provide a quote for the contactor replacement upon approval.

Schedule Commercial AC Maintenance in Austin

Whether your facility runs a single rooftop unit or a multi-system setup, regular preventative maintenance is the most cost-effective way to extend equipment life and avoid surprises. Setpoint Services provides commercial HVAC repair and scheduled maintenance throughout Austin and Central Texas.

Call us at 512-992-5537 or visit our contact page to schedule service.

Setpoint Services LLC — Keeping Austin’s Commercial Equipment Running Right.