hot_to_cold

Austin Texas and Surrounding Areas

Request a Free Quote

→ Fill Out the Form

Or Just Give Us A Call

512-992-5537


    Tito
    6/4/2026
    9616 N Lamar #187 Austin, Texas 78753
    Setpoint Services completed a commercial refrigeration repair for a Domino's Pizza location in Austin, Texas after a rail cooler/prep table refrigeration system failed to maintain temperature. Upon arrival, the refrigeration system was found completely out of refrigerant and operating in a vacuum condition. A leak search located a refrigerant leak at the drain line heater bend. The leak was repaired, pressure tested, evacuated, and the system was recharged with R-404A refrigerant. During startup, additional refrigerant flow issues were discovered, causing the system to repeatedly pull into a vacuum and trip the low-pressure safety control. Further diagnostics identified contamination and restrictions within the refrigeration circuit. Setpoint Services flushed the refrigerant lines, replaced the liquid line filter drier, replaced both liquid line solenoid valves and solenoid coils, and installed a new low-pressure safety switch. During testing, the compressor was found to be mechanically locked and unable to operate. A new compressor was installed, the refrigeration system was evacuated to a deep vacuum, and the unit was recharged with the factory-specified refrigerant charge. After startup, system operation, compressor performance, refrigerant flow, and low-pressure safety controls were verified. Final testing included adjustment of the rail evaporator TXV to improve refrigerant feed and cooling performance. Rail temperatures improved significantly following repairs and adjustments. The rail cooler was operating and cooling at the completion of service. Services Performed: • Commercial rail cooler repair • Refrigerant leak detection and repair • R-404A refrigerant recovery and recharge • Refrigeration system flushing and cleanup • Liquid line filter drier replacement • Liquid line solenoid valve replacement • Low-pressure safety switch replacement • Commercial refrigeration compressor replacement • TXV adjustment and system performance testing • Condenser coil cleaning • Commercial refrigeration diagnostics and repair If your restaurant prep table, rail cooler, pizza prep station, or commercial refrigeration equipment is not holding temperature, Setpoint Services provides commercial refrigeration repair throughout Austin, Round Rock, Cedar Park, Georgetown, and surrounding Central Texas areas.
    Tito
    6/4/2026
    8204 N Lamar Blvd, Austin, TX 78753
    Setpoint Services performed EPA-compliant refrigerant recovery service for a commercial walk-in cooler refrigeration system in Austin, Texas. Technicians documented operating conditions and inspected refrigeration components prior to system decommissioning. Heavy evaporator icing was discovered restricting airflow and indicating underlying refrigeration performance concerns. Temporary service fittings were installed to facilitate refrigerant recovery due to access limitations. Approximately 10–12 pounds of R448A refrigerant were safely recovered and secured in approved recovery cylinders. Refrigeration equipment was prepared for future removal and replacement operations. This project included refrigerant recovery, walk-in cooler service, commercial refrigeration decommissioning, EPA refrigerant handling, and refrigeration system preparation in Austin, Texas.
    Tito
    6/3/2026
    6507 Circle S Rd, Austin, TX 78745
    Setpoint Services completed walk-in cooler repair and commercial refrigeration service for a beer cooler refrigeration system in Austin, Texas. Customer reported refrigeration performance issues affecting cooler operation and temperature control. Technicians installed a new refrigeration defrost timer and performed extensive refrigeration diagnostics. Additional troubleshooting revealed an incorrectly installed liquid line solenoid coil and a failed low-pressure control preventing proper pump-down operation. Both components were replaced and system controls were reconfigured to manufacturer specifications. The refrigeration system was tested through multiple cooling and defrost cycles to verify operation. Defrost schedules were programmed and refrigeration performance was monitored to confirm proper operation. This project included walk-in cooler repair, beer cooler repair, commercial refrigeration service, refrigeration controls repair, and restaurant refrigeration maintenance in Austin, Texas.
    Tito
    6/3/2026
    Near Cedar Ridge Drive, Austin TX 78741
    Setpoint Services completed cold plunge chiller diagnostics and refrigeration system repairs in Austin, Texas. Customer reported system failures affecting water circulation, cooling operation, and overall performance. Technicians diagnosed multiple electrical and control component failures including a failed power supply, failed circulation pump power brick, and defective circulation pump assembly. Replacement components were installed to restore water flow and system functionality. Additional testing identified a failed temperature control board, failed Wi-Fi control module, and failed heating element requiring future replacement. Detailed diagnostics were completed and recommendations were provided for complete system restoration. This project included cold plunge chiller repair, refrigeration diagnostics, circulation pump replacement, control board troubleshooting, and refrigeration service in Austin, Texas.
    Tito
    6/3/2026
    117 W 4th St Unit 107B, Austin, TX 78701
    Setpoint Services completed commercial refrigerator repair for a restaurant refrigeration system in Austin, Texas. Customer reported a reach-in refrigerator door falling off and failing to close properly, creating temperature control concerns and refrigeration efficiency issues. Technicians removed damaged door hardware and installed replacement hardware to restore proper door alignment and sealing. During inspection, additional refrigeration system issues were discovered involving damaged door switch mounting components that were affecting evaporator fan operation and interior lighting circuits. Temporary repairs were performed to maintain refrigeration operation while recommendations were provided for permanent door switch assembly replacement. The reach-in refrigerator was tested and verified operating properly upon completion. This project included commercial refrigerator repair, reach-in cooler repair, restaurant refrigeration service, refrigeration maintenance, and commercial kitchen equipment repair in Austin, Texas.
    Tito
    6/3/2026
    13010 W Parmer Ln Ste 400 Cedar Park, Texas 78613
    Reach-In Glass Door Freezer Compressor Replacement – Cedar Park, Texas Unit Information Brand: B Series Glass Door Freezer Model: MCF8703GR Serial Number: MCF8703GRAUS100319052400C40011 Compressor Information Brand: Embraco Model: NEU2168U Description of Work Performed Arrived onsite in Cedar Park, Texas, to diagnose a reach-in glass door freezer that was not maintaining proper temperature. Confirmed compressor failure and replaced the failed compressor with a new OEM-compatible Embraco NEU2168U compressor. Recovered the existing refrigerant charge and removed the defective compressor. Installed a new liquid line filter drier and added refrigeration service access ports to improve future diagnostics and serviceability. Pressure tested the refrigeration system and verified no leaks were present. Pulled the system into a deep vacuum to remove moisture and non-condensables, then recharged the unit with 150 grams of R290 refrigerant per manufacturer specifications. Cleaned the condenser coil to improve airflow and overall system efficiency. Started and tested the unit, verifying proper compressor operation, refrigerant flow, and cooling performance. Monitored operation and confirmed the freezer was pulling down temperature normally. Final operating pressures recorded: Suction Pressure: 15 PSIG Discharge Pressure: 180 PSIG Unit was operating normally and cooling properly at the time of departure. Repairs Performed Compressor replacement Liquid line filter drier replacement Refrigerant recovery and recharge Refrigeration system pressure test Deep vacuum evacuation Installation of refrigeration service access ports Brazing and startup procedures Condenser coil cleaning Operational testing and verification Location: Cedar Park, Texas

    We are Factory Authorized Representatives for Several Commercial Refrigeration Systems!

    Setpoint_Services_Video_Overlay
    Setpoint_Services_Logo

    Why Choose Us for Commercial Refrigeration

    Here at Setpoint Services LLC, we are committed to keeping your equipment running efficiently and cost-effectively. Whether it’s a walk-in cooler, HVAC system, or ice machine, we provide reliable repairs, installations, and preventative maintenance services to meet your unique needs.

    We specialize in:

    • Walk-in Coolers/Freezers
    • Ice Machines
    • Wine Coolers & HVAC Systems
    • Energy Management Solutions

    Our expertise extends to a wide variety of businesses, including local food retailers, convenience stores, medical and drug stores, ice plants, and restaurants. We don’t just fix the problem—we ensure you understand what’s needed to get your equipment back in top shape, and we work to minimize downtime and prevent future issues.

    We also understand the importance of controlling energy expenses. That’s why we offer energy management solutions that can help reduce your operational costs. Plus, if your unit qualifies, we can provide extended labor and parts warranties to give you added peace of mind.

    Read More

    License & Certifications

    Texas TACLA00116720C

    4.9